Behringer Ultrabass BX4410, User Manual

Page: 6 / 10

6
ULTRABASS BX4410/BX4410A
3. WIRING EXAMPLES
+
When the built-in limiter is activated, the LED below
the OUTPUT control lights up.
Connect the SEND/TUNER output to the input of your
effects device, for example, our proven multi-effects
processor BEHRINGER VIRTUALIZER PRO DSP2024P.
This output can also be used to connect your tuner.
Connect the
RETURN jack to the output of your effects
device. Since the BX4410/BX4410A features a serial
effects path, the mix ratio must be set on your effects
device.
Use the balanced
D.I. XLR output to feed the audio signal
from your ULTRABASS to an external mixing console. The
D.I. signal is wired post-EQ.
Use the
LINE OUT jack to connect your BX4410/BX4410A
to a mixing console that has no balanced inputs and/or to
provide a signal that is independent of all settings adjusted
on the BX4410/BX4410A.
+
The LINE OUT output is wired post effects loop
& and can also be used to feed the output signal
of your BX4410/BX4410A to an external bass amp.
2.2 Rear panel
Fig. 2.4: BX4410/BX4410A rear panel (section 1)
Use the POWER switch to switch the BX4410/BX4410A
on or off. You should always make sure that the POWER
switch is in the “Off” position when initially connecting the
unit to the mains.
To disconnect the unit from the mains, pull out the main cord
plug. When installing the product, ensure that the plug is
easily accessible. If mounting in a rack, ensure that the
mains can be easily disconnected by a plug or by an all-pole
disconnect switch on or near the rack.
+
Please note: Merely switching the unit off does not
mean that it is fully disconnected from the mains.
When not using the unit for prolonged periods of
time, please unplug the unit’s power cord from the
power outlet.
MAINS CONNECTION . Use the power cord supplied with
the unit to connect it to the mains.
FUSE HOLDER/VOLTAGE SELECTOR . Before
connecting the unit to the mains, make sure that the voltage
setting matches your local voltage. A blown fuse should
only be replaced by a fuse of the same type and rating. On
some units, the fuse holder can be switched to one of two
positions, i.e. 230 V and 120 V. When operating the unit
outside Europe at 120 V, a higher fuse rating is required.
SERIAL NUMBER .
Fig. 2.5: BX4410/BX4410A rear panel (section 2)
The internal speakers of the BX4410/BX4410A are
connected to the 1/4" SPEAKER output jacks. They can
also be used to connect external loudspeakers. For further
speaker connection you find a professional loudspeaker
connector (compatible to Neutrik
®
Speakon
®
).
+
Your speaker cabinets should have a sufficient
power rating (>450 W) and preferably a total
impedance of 4
W
to avoid speaker damage. Too
high a load impedance will decrease the output
power rating of the power stage!
+
For correct speaker connection please also refer
to chapters 3.3, 3.3.1 and 6.2.1!
3. WIRING EXAMPLES
This chapter is aimed at describing and illustrating basic wiring
examples.
3.1 Standard setup comprising footswitch
and external loudspeaker
The standard setup is intended for rehearsals, sessions and
club gigs.
Fig. 3.1: Standard setup