4
TUBE CONDENSER MICROPHONE T-47 User Manual
Control elements and connections
2.
Microphone
2.1
You can tell that the T-47 is switched on when the small window glows red.
There is an XLR connector on the bottom end of the microphone. Connect it to
the power supply (PSU-T).
Power supply
2.2
The included BEHRINGER PSU-T not only provides the supply voltage for the
tube preamplifier but also employs a circuit that reduces the low frequency
response. This is activated on the front panel with the
LOW CUT
switch.
The
POWER
switch on the unit's rear panel turns on the power supply.
Here you also find the following:
a seven-pin XLR connector to connect to the T-47 (
•
MIC
),
a three-pin XLR connector to transmit the signal (
•
OUTPUT
),
a switch to suppress signal humming noise (
•
GND LIFT
),
an
•
IEC
power receptacle
and a fuse holder.
•
Use the provided cable to connect the T‑47 to the
◊
power supply unit!
