5
MINIMIX MIX800 User Manual
(4)
EQ LOW
. The EQ LOW control allows you to raise or lower the
low-frequency content of the microphone signal.
(5)
EQ HIGH
. With the EQ HIGH control, you can raise or lower the
high-frequency content of the microphone signal.
(6)
ECHO/REVERB
. The MIX800 allows you to add an effect to the
microphone signal. When the ECHO/REVERB button is pressed
in, you can add REVERB to the signal. When the button is
pressed out, the ECHO effect is active.
◊
1 of the 2 effects is always active! Use the FX LEVEL control
(7)
to switch off the effect or to adjust the effect intensity.
(7)
FX LEVEL
. The FX LEVEL control determines the amount of effect
that is added to the master signal.
◊
Turn this control fully to the left to switch off the
active effect.
(8)
IN/OUT
. Press the IN/OUT button to activate the Voice Canceller
in the signal path. This filter circuit allows you to remove the
vocals almost completely from a recording. The filter has been
designed so that vocal frequencies will be processed without
significantly affecting other music signals. What is more,
the filter only works in the center of the stereo panorama,
where vocals are usually positioned in a recording.
◊
The Voice Canceller can be used for stereo signals only!
(9)
OUTPUT LEVEL
. Set the volume of the output signal with the
OUTPUT LEVEL control.
(10)
LED DISPLAY
. The LED display is for monitoring the input level.
It comprises 6 LEDs. When the Clip LED lights up, distortion may
occur in the MIX800 output. Reduce the output level with the
OUTPUT LEVEL control
(9)
.
(11)
�
SWITCH
. The
�
switch turns your MINIMIX MIX800 on
and off.
◊
Attention: The
�
switch does not fully disconnect the
unit from the mains. To disconnect the unit from the
mains, pull out the main cord plug or appliance coupler.
When installing the product, ensure the plug or appliance
coupler is readily operable. Unplug the power cord
completely when the unit is not used for prolonged periods
of time.
2.2 The rear
(12)
(15)
(13)
(14)
Fig. 2.2: Rear panel connectors of the MIX800
(12)
Use the 9 V jack to connect the power supply delivered with
the unit.
(13)
These connectors are the unbalanced cinch outputs of
the MIX800.
(14)
These connectors are the unbalanced cinch inputs of
the MIX800.
(15)
SERIAL NUMBER
.
3. Application Example
The wiring example shown below gives you an idea of how to use
the MIX800.
XM1800S
CD-Player
IN
L
IN
R
OUT
L
OUT
R
EUROPOWER
EP2000
EUROLIVE B1520 PRO
Fig. 3.1: Using the MIX800
Summary of Contents for MINIMIX MIX800
Page 8: ...We Hear You...
