Behringer D A-440, User Support Bulletin, Page: 4 / 23

Synthesizers and Samplers
MODEL D
page 4 of 23 page 4 of 23
MODEL D Control Settings for Calibration
KNOBS
TUNE 0
GLIDE 0
MOD MIX *
MOD DEPTH 0
LFO RATE 0
SWITCHES
OSC3/FILTER EG *
NOISE/LFO *
SQR/TRNG *
* NO PREFERENCE
KNOBS
OSC1 RANGE 8’
OSC2 RANGE 8’
OSC3 RANGE 8’
OSC1 WAVEFORM SAWTOOTH
OSC2 WAVEFORM SAWTOOTH
OSC3 WAVEFORM SAWTOOTH
OSC2 TUNE 0
OSC3 TUNE 0
SWITCHES
OSCILLATOR MOD OFF
OSC3 CONTROL ON
KNOBS
OSC1 VOLUME 10
OSC2 VOLUME 10
OSC3 VOLUME 10
EXT IN VOLUME 0
NOISE VOLUME 0
OSC1 SELECT ON
OSC2 SELECT OFF
OSC3 SELECT OFF
EXT IN SELECT OFF
NOISE SELECT OFF
SWITCHES
WHITE/PINK *
* NO PREFERENCE
KNOBS
MAIN VOLUME *
PHONES VOLUME *
SWITCHES
MAIN OUT *
A-440 ON
* VOLUME AS NEEDED
KNOBS
CUTOFF FREQ 5
FILTER EMPHASIS 0
AMOUNT CONTOUR 0
FILTER ATTACK 0
FILTER DECAY 0
FILTER SUSTAIN 0
LOUDNESS ATTACK 0
LOUDNESS DECAY SEC
LOUDNESS SUSTAIN 10
SWITCHES
FILTER MODE LO
FLTR MODULATION OFF
KEYBRD CONTROL1 OFF
KEYBRD CONTROL2 OFF
FILTER DECAY OFF
LOUD DECAY OFF
EXTERNAL KEYBOARD
MOD WHEEL DOWN
PITCH WHEEL CENTERED
Turn off the MODEL D power.
Try and do the following steps quickly and carefully to keep any cooling down to a minimum.
Lifting off the top panel
Turn on the MODEL D rear panel power switch and check that its Power LED comes on.
Important: Leave the MODEL D turned on for approximately 30 minutes. This will allow the circuits time to warm up
and the components and performance to stabilise with temperature. Without this warm-up time, the calibrations will
be inaccurate.
Set the MODEL D controls as shown below.
Turn down the MODEL D headphone volume knob, and connect your headphones to the MODEL D headphones
output connector. Alternatively, you can monitor the MODEL D output using the main outputs and a suitable sound
system and speakers.