– 7 –
behr InKjel P
© behr Labor-Technik 2014
142109
Setting Up the InKjel P
Danger of electric shock!
Always install all cables in such a way that
they cannot come into contact with the hot
zone of the heating cavity; they could oth‑
erwise smoulder through! Always ensure
that no liquids can come into contact with
cable connections or the interior of device!
Always withdraw the mains plug before
opening the unit! Repairs on electrical,
electronic and mechanical modules of
this appliance may be performed only by
authorized specialist staff.
Fixing the mounting rack
Place the base unit on a level horizontal surface in
such a way tha the mounting brackets point to the
rear.
Insert the mounting rack between the mounting
brackets from above. Do not push them down to the
bottom but align the lower edges of the rails with the
lower edges of the mounting brackets.
Place a washer on each of the knurled screws, and
screw the mounting rack to the mounting brackets
with the knurled screws.
Inserting the Equipment
Hang the sample rack into the lower hooks of the
mounting rack.