13
Resolution
1 Hz
Tolerance
±(5% +5dgt)
Sensetivity
> 10V
Low Resistance Indication (L Rx)
Range
<20 Ω, same LED as Rx
Diode Test
Yes
General Specifications
LCD overrange
indication
“OL”
Measurement
area illumination/
Flashlight
White LED
Backlight
LED
Temperature
-15…55°C operation;
-20…70°C storage; No condensation
Humidity
Max. 85% RH
Operating altitude
Up to 2000 m
Safety rating
(overvoltage
category)
CAT IV / 600 V, CAT III / 1000 V
Safety regulations
IEC 61243-3:2014, EN 61243-3:2014,
DIN VDE 0682-401:2015,
IEC/EN 60529
Open jaw: IEC/EN 61010-1,
IEC/EN 61010-2-032
Electromagnetic
Compatibility (EMC)
IEC 61326-1
Protection degree
IP64
Pollution degree
2
Approvals,
compliance
Battery
3 V (IEC LR03 /AAA 2x 1.5 V)
Internal battery
consumption
Approx. 120 mA
Battery lifetime
More than 10000 measurements
(<5 s / per measurement)
Dimensions
(HxWxD)
Approximately 210 x 63 x 37 mm
(6.3 x 2.5 x 1.5 in)
Weight
approximately
275 g (0.61 lb)
MAINTENANCE AND REPAIR
According to the operating instructions the voltage tester do
not require any special maintenance for operation. However,
if a malfunction occurs during operation, the measurement
has to be stopped and a further measurement is not allowed.
The unit has to be tested at our factory service department.
Except for the replacement of the battery, any repair of
the instrument should be performed only by an Authorized
Service Center or by other qualified instrument service
personnel.
W
If the instrument is not used for a prolonged period,
the batteries must be removed, as leaking batteries may be
hazardous and cause damages.
Cleaning
Before cleaning, disconnect the voltage tester from all
measuring circuits. If the instruments have become dirty
due to daily use, they can be cleaned with a damp cloth
and a little mild household detergent. Never use aggressive
detergents or solvents for cleaning. After cleaning, do not use
the instrument until it is completely dry.
