Figure 1
Figure 5
Figure 6
Figure 7
Figure 8
Figure 10
Figure 9
120-347 VAC
LED LIGHT
SOURCE
BATTERY
+
-
+
-
L (black)
N (neutral)
G (green)
LED LIGHT
SOURCE
LED SIGN
(red connector)
926000229
Figure 2
Figure 3
Figure 4
Loop lock
AC/LED
wires
Tie pad
Tie wrap
Bump
Notch
Plastic
Bushing
Swing to vertical
position
Tie pad
Max. mounting height is 14.5 ft to get an
average illuminance above 1 fc, based on
3x3 ft room 80/50/20 reflectance.
Base assembly
Base
Cover
TROUBLESHOOTING
EXIT SIGN DOES NOT COME ON AT ALL
1. Check AC supply and all AC connections - be sure sign has 24 hour AC supply (unswitched).
2. Check supply voltage and AC connections. The AC supply must be at least 80% of nominal (96V on a 120V line)
for equipment to function normally. At lower voltages the LEDs will begin to glow dimly until the source voltage
drops below the full “turn-on” point.
NOTE: This condition may also be caused by incorrectly connecting a 120 Volt supply line to the
capacitor assembly lead.
3. AC supply is OK; replace LED circuit board assembly
MAINTENANCE
1. The lamps listed herein when used according to the instructions with this unit are in accordance with the requirements
of CSA Standard C22.2, No. 141 – Unit Equipment for Emergency Lighting.
2. Clean face(s) on a regular basis.
NOTE: The servicing of any parts should be performed by qualified service personnel only. The use of replacement
parts not furnished by Beluce Canada Inc., may cause equipment failure and will void the warranty.
Cut loop
lock
Beluce Canada Inc., 3900 14th Avenue, Markham, ON L3R 4R3 Tel: (905) 948-9500 Fax: (905) 948-8673
04/09/2019
