5
Leveling the Platform
To level or adjust the height of the scale platform, carefully lift the platform and
adjust the leveling feet by screwing them in or out as needed. When leveled
properly, the scale should rest evenly on all four feet.
NOTE:
Use caution when using scale on shag carpeting or similar surfaces. An incorrect
reading will result if the platform touches the floor or carpeting.
Mounting Bracket
Battery Installation
This scale is powered by four (4) disposable D-cell alkaline batteries and features
Befour’s exclusive ECO Weigh system that will provide 100,000+ weighings.
Use the following procedure when installing a new set of batteries:
1.
Using a medium Phillips screwdriver, loosen the two screws on the left side of
the control console.
2. Gently slide the battery tray out until it stops,
about 3 inches.
3. Remove old batteries if necessary.
4. Insert new batteries as shown on the bottom of
the tray.
5. Slide tray back into control console and
tighten the screws to secure closed.
Figure 3: Battery Tray
NOTE:
Do not attempt to slide the tray out past its stops. When replacing old batteries,
always use four fresh ones.
A mounting bracket is pre-installed on the back side of the display console You
have three options to view your display console.
Option One: Console Flat on Surface
The console can lay flat on any surface. The wire arm should be flat against the
console bottom as show in Fig. 1.
Option Two: Wall Mounted
The bracket has two teardrop shaped holes used to mount the console to a wall
(Fig 1). You will need to drill two holes 5-3/4” apart. We recommend using wall
plugs and screws and leaving a 1/8” gap from screw head to the wall. Position
the console so the screw heads align with the large opening in the teardrop
holes and lower into place.
Option Three: Table-top Mounted
Rotate the wire arm until it is locked into the slots in the plastic bracket. The
console can now be positioned as shown in Fig. 2.
