CLOCK I N
Synchronize Muxlicer with an incoming clock signal. Each rising edge, it will advance an
amount of steps that depend on the “Div/Mult” setting. Muxlicer automatically detects
when something is plugged to this IN switching from Internal to external clock.
Every time
that a cable is plugged to its Input, Muxlicer resets the "Div/Mult" setting to 1 /1 .
M U X L I C E R
R E F E R E N C E
F U N C T I O N A L
B L O C K S
U S E R M A N U A L
D I G I TA L S T E P C O N T R O L L E R
.4
GATE M ODE
This knob and its associated IN, controls Gates behaviour. Moving the knob clockwise (or
adding CV at the CV IN) gates will change behaviour on the next sequence:
1.
No Gate
2.
Gate = Step Time
3.
Half Step Time
4.
Two Gates per Step
5.
Three Gates per Step
6.
Four Gates per Step
7.
Five Gates per Step
8.
Six Gates per Step
9.
Seven Gates per Step
10.
Eight Gates per Step
Turning On the module while
pressing up the Play Switch
removes all the steps from
Gate Mode
that are not
Quadratic (1 , 3, 5, 6, 7)
To come back to normal Gate
behaviour just repeat the
procedure.
Gate Mode IN, is normalized to 1 0v so the knob acts as a manual control when no CV is
present. When CV is present the Knob acts as an attenuator. 1 0v CV are accepted, but
most usable range is from 0 to 5v. Other voltages are ignored.
CLOCK OU T
Outputs the clock (either internal or external) divided or multiplied by an entire number.
By default it initializes after Play or Play One shot, and stops when Muxlicer stops
counting. If you want the opposite behaviour so it always keep running even if you stop
the module,
hold the Play switch up for three second while the module stopped
(you
will see the Clock led frozen for one second). Turning On the module while pressing down
the Play Switch removes all the steps from
Clock Out
that are not
Quadratic.
EOC (En d of Cycl e) OU T
Outputs a short trigger when the count reach the
end of the step 8.
It works only during play and
not if step eight is reached with Address IN.
Is
useful for chaining more than one Muxlicer in
series or to trigger any other event like envelope
s.
GATE OU TS
Output gates each
time the associated
step is activated
depending on the
Gate Mode Knob and
the corresponding CV.
ALL GATES OU T
Outputs a digital sum of all the
gates (logical OR)
GATE LEDS
This LEDs blink always when
a Gate is active. They indicate
also which step is active at
this time.
F U N C T I O N A L
B L O C K S
G A T E G E N E R A T O R
All manuals and user guides at all-guides.com
all-guides.com
