MORPHADER PRESOLDERED - ASSEMBLY GUIDE Rev. April 21
SWITCHES
Place the switches
in their right places.
don't solder them yet!
Qty Type
Name on PCB
4
Mini. Two circuits two position
S1, S2, S3, S4
POTENTIOMETERS
Now place the potentiometer on the PCB but...
don't solder them yet!
Qty Type
Name on PCB
10 Single (3pin) B100k
CROSS_CV_ATT1, ATT_1A, ATT_1B, ATT_1A1, ATT_1B1, ATT_1A2,
ATT_1B2, ATT_1A3, ATT_1B3, LAG
LEDs
Place the LEDs onto main PCB minding its polarity, but
don't solder them
until the front panel is in
place. This is the only way to solder them the right position.
Qty
Type
Name on PCB
8
Red LED 2mm
A, A1, A2, A3, A4, A5, A6, A7
FRONT PANEL
Attach the
front panel
adjusting the parts one by one if necessary until it fits. At this point a
pair of fine tweezers can be helpful.
To Finish:
- Screw in the parts in this order: A)
Mini-jacks
B)
Pots.
- Ensuring all of the above parts are flush with the panel and both PCB and panel are
perfectly parallel. Then you can
finally solder
them!
- Fit the LEDs on the panel holes and solder them
- Put the
knobs
on the potentiometers and the Black cap on the Fader.
- Connect the
power ribbon cable
: The red wire (-12V) on the power ribbon cable
corresponds to pin number one on the male power connector. The number one pin is
indicated with a small triangle on the male power connector and a white line on the main
PCB. A white or black line (or “-12v”) marked on your power bus normally indicates the
corresponding pin.
ENJOY YOUR NEW
BEFACO
MODULE!
2
