5. USE OF THE PRODUCT
31
D. Connection of the sensors with the display
/!\ By default, the sensors are connected with the display. Thus, this operation is only to realize in case of the replacement of one of the sensors.
Press on the “
SET
” button 5 times to hear a long beep sound. The system enters then in adjustment mode. Then press on the “
SET
” button to select which tire you
whant to connect with the sensor, then slacken a little air by the valve of the tire, until you see the value of pressure on the screen. Press on the button “SET” until
you hear a beep sound. Repeat the previous stages to connect the other sensors. Once the adjustments are finished, press on the “
SET
” button for approximately
3 seconds to leave the adjustment mode. Then, you will hear 2 beep sounds. Note: If there is no operation made during 3 minutes, the system leaves automatically
the adjustment mode.
E. Adjustment of the units of measure (pressure and temperature)
> Press the “
SET
” button for approximately 3 seconds (until you hear a long beep sound), to enter on the adjustment mode of the unit of pressure. Then press on
the “
SET
” button to display either PSI or BAR. Then select the unit of pressure that you prefer, then press a long time on the “
SET
” button, until you hear two beep
sounds.
/!\ The high value of pressure alarm is of 3.3 bars and the low value of pressure alarm is of 1.8 bars.
> To enter on the adjustment mode of the temperature unit, press the “
SET
” button for 5 times in a row. Then, select the unit of temperature that you prefer (°C
or °F) and than press the “
SET
” button to confirm your choice.
/!\ The value of temperature alarm is of 70°.
