21
EN
Samovar
2017
BEEM - Elements of Lifestyle
Heating water
CAUTION
Make sure that the rotary knob (8)
►
is turned to the
Off
position. Then
insert the plug into the mains socket.
To heat up water, proceed as follows:
Fill the water tank with the desired
quantity of fresh water. Pay attention
the maximum filling level (15).
Close the lid of the water tank and
subsequently put the teapot on top
of it.
Turn the rotary knob clockwise until
the desired setting is reached.
The thermostat allows individual setting
of the water temperature. You have the
choice between the following settings:
warm, hot, boiling water and intermittent
boiling as described in the section
Rotary
knob (page 20)
.
Boiling
If you turn the rotary knob (8) until it stops
at the the
BOIL
position, the water is
boiled quickly. If you leave the switch at
this position, the water will continue boiling
until it has completely evaporated.
Intermittent boiling
After the water has boiled, turn the rotary
knob (8) back until the indicator light (11)
extinguishes. This switches the appliance
to intermittent boiling. The appliance then
switches itself on again and starts heat-
ing when the water temperature drops.
The thermostat then controls the power
supply as required and saves energy. The
thermostat cycle switches the indicator
light (11) on and off.
Refilling with water
WARNING
Filling up the hot container can cause
steam to escape and lead to scalding!
Turn the rotary knob (8) clockwise until
►
it stops at the
Off
position.
Allow the appliance to cool down for a
►
few minutes before refilling with water.
NOTE
If you forget to fill with water, the
►
boil-dry protection will switch off the
appliance.
Then fill the appliance again with
►
water.
Summary of Contents for S 2.3.17
Page 2: ......
Page 3: ...BEEM Elements of Lifestyle 3 4 5 6 7 8 11 14 12 13 9 10 15 11 8 2 1 17 16...
Page 4: ......
Page 53: ......