BEEM – Elements of Lifestyle
22/56
NOTE: Hang the washing to be ironed where heat and moisture cannot cause
any damage. Never hang the washing in front of wallpaper, windows or mirrors.
ATTENTION: The steam pipe gets hot after long steam operation.
7.
Use the same procedure as for normal steam ironing to switch off.
6.4
Dry ironing
1.
Put the plug into the socket.
2.
Switch on the steam generator.
The indicator light comes on and a beep tone is sounded.
3.
Press the steam volume button until all the steam indicator lights are off.
4.
Select the desired ironing temperature with the temperature selector switch.
The selected setting flashes whilst the iron is heating up. The ironing temperature is
reached when it stops flashing.
NOTE: Press the steam button about every 15 minutes, otherwise the automatic
switch-off function will become active and the utensil switch off.
5.
Set the iron to level • to switch off and replace it on the steam generator.
6.
Press the button on the steam generator and then pull out the mains plug.
7.
Faults and troubleshooting
The utensil is equipped with a safety valve. If the steam pipe is blocked, the safety valve
opens and the steam escapes under the utensil. This produces a high whistle. If this is the
case, switch off the utensil immediately, pull out the plug and check the steam pipe for
possible damage or kinks. If you cannot find anything wrong, clean the utensil as described in
section 8 and change the filter cartridge (section 8.3).
Faulty
function
Possible reason
Remedy
The utensil is not switched on.
Switch the utensil on with the on/off
switch on the steam generator.
The steam iron
stays cold.
The temperature is on •.
Set the necessary temperature.
The steam generator is not switched
on.
Switch on the steam generator.
The filter is not inserted in the water
tank.
Insert the filter in the water tank.
The water tank has hardly any water
in it or is empty.
Fill with water.
The utensil does
not produce
steam.
The water tank is not inserted in the
steam generator correctly.
Insert the water tank so that it clicks in
audibly.
The steam pressure button has been
kept pressed for too long and the
Heat indicator on the steam
generator lights up.
Wait until the iron has reheated. The Heat
indicator on the steam generator goes
out. If this does not help, select a lower
steam volume briefly.
Water drips
from the sole of
the iron. This is
normal when
starting ironing
or after short
breaks (cold
hose and the
steam
condenses).
The temperature of the iron is off
(position •) or too low (position
Synthetic).
At least level Wool/Silk must be selected
for steam ironing. Select a higher
temperature on the iron.
Summary of Contents for G-1030ST-E-CERAMIC
Page 54: ...BEEM Elements of Lifestyle 54 56...
