3
Phillips Head
Screwdriver
adjustable
spanner/wrench
Allen key
Assembly Instructions
Fit the axle through the holes in the end of
the base panel. Fit the wheels as shown.
Before You Start
Note the tools you will need before you begin.
Check for damaged or missing parts, and
consult your retailer if necessary.
Many components and panels are covered
with a protective sheet of plastic. You will
need to remove this plastic covering from all surfaces, especially where two panels join. It is a good idea to
leave some plastic on the panels during assembly to protect the stainless steel during the assembly process.
Ensure however that all plastic covering is removed on completion.
Assemble on a clean, smooth, flat working surface that will not scratch the surface of the stainless steel..
1a) Fit The Fixed Wheels
2) Fit The Rotating
Castors
Fit the rotating castors into the holes
in the bottom of the base. Use only
two Allen head screws, washers and
nuts for each castor in the positions
shown.
Spanner/wrench tighten immediately.
Fit the circlips to the grooved ends
of the axle shaft. Fit the hubcaps.
1b) Fit The Circlips
and Hub Caps
