Beef Eater i-1000R, Assembly And Operating Instructions Manual

Page: 20 / 32

20
CONNECTION TO BARBECUE & GAS SUPPLY
Gas connection : Connect the hose to the gas inlet on the
right hand side of the barbecue�
Tighten with a spanner (wrench) but do not over-tighten�
Connect the regulator end of the hose to the gas cylinder as
shown� Ensure the hose does not twist or kink�
Regulators which fit inside the mouth of the cylinder valve
are tightened anti- clockwise�
Regulators which screw onto the outsdie thread of the
cylinder valve are tightened by turning clockwise�
On completion : The appliance must be tested for safe and
proper operation on completion of installation� Proceed to
leak test�
Regulators which fit inside the
mouth of the cylinder valve
are tightened anti- clockwise�
Regulators which screw onto
the outsdie thread of the
cylinder valve are tightened by
turning clockwise�
Leak Test
The gas leak testing procedure should be conducted every
time a gas cylinder is refilled and reconnected to the
appliance, or after any new gas connection is made.
Never use a naked flame to check for gas leaks�
In a small container, mix up a solution of water and
detergent or soap�
Mix the solution well!
Make sure that the gas supply valve on the gas cylinder or
the shut off valve on the supply line is turned on�
Make sure that the gas control valves on the appliance are all
turned off�
Using a brush or spray bottle apply the solution to the gas
line and each joint in the gas line, including the hose and
regulator�
Bubbling of the solution will indicate that there is a leak
present� Re-tighten or re-seal any joints that are leaking�
If a leak persists contact your distributor or the manufacturer
for assistance�
Disconnecting The Gas Supply
If you need to disconnect the gas supply for any reason,
always ensure that all gas controls on the appliance and on
the cylinder are off before disconnecting or removing the
gas cylinder� Do not smoke or use a naked flame near the
appliance or gas cylinder while connecting or disconnecting
the gas line�
If installed in an enclosure, remove the gas cylinder from
the enclosure before disconnecting the gas line from the
appliance� Tighten all connections before placing the gas
cylinder back in its enclosure�
CONNECTION TO BARBECUE & GAS SUPPLY