Master/Slave Mode
Multiple BEEMOVE 7x10W can be operated in sync.
In this mode, one unit (master unit) controls the other units (slave
units). Connect the units in a chain.
On the master unit, call up an automatic or music-controlled program.
1) Press the button
MODE/ESC
until the display indicates :
EASy.
2) Press the button
ENTER
to confirm your choice.
3) Press the button
UP&DOWN
, select the desired mode:
MAFA,-
MASL, and MStS.
4) Press the button
ENTER
to confirm your choice.
Proceed as follows to set the slave units to slave operation:
1) Press the button
MODE/ESC
until the display indicates:
EASy.
2) Press the button
ENTER
to confirm your choice.
3) Press the button
UP&DOWN
, select the mode:
SLAv.
4) Press the button
ENTER
to confirm your choice.
A slave unit may also be synchronously controlled in a mirror-inverted
way with regard to the master unit. For this, the pan and tilt directions
can be inverted. ( please check chapter «Pro Mode»)
DMX Mode
For operation via a DMX light controller, the BEEMOVE 7x10W is
equipped with 14 DMX control channels. If all control options are not
required or if the controller does not provide 14 control channels, the
BEEMOVE 7x10W may be switched to 9 DMX control channels.
Connect the control INPUT (5) to the DMX output of the light control
-
ler or to the DMX output of another DMX-controlled unit. Connect the
control OUTPUT (6) to the control input of the following DMX-controlled
unit. Connect the output of this DMX-controlled unit to the input of the
following unit etc. until all DMX-controlled units have been connected in
a chain.
