3
Assembling Your Stand
1
Attach Ring and Rear Bracket to Backboard
You will need:
Hoop/Ring (part 2)
Backboard (part 1)
Backboard Bracket (part 4) - ensure you have bent the top struts outwards ready for the first step
4 x Bolts, Nut & Washers A (M8 x 50mm)
2 x Bolts & Washers B (M8 x 16mm)
Fix the Hoop/Ring (part 2) to the front of the Backboard (part 1), and the Board Bracket (part 4) to the back using
Bolts , Nuts A - there should be four in total plus eight washers (one washer for each bolt and one for each nut).
The bolts go through the back plate on the ring, then the backboard, then the board bracket and out the back to
be fixed in place using the nuts.
Fix the top of the Backboard Bracket to the Backboard using the two Bolts & Washers B.
2
You will need:
Parts as assembled in Step 1
Top Pole (part 6)
Pole Top Cap (part 5)
2 x Bolts, Nuts & Washers C (M12 x 90mm)
We recommend carefully laying the backboard on its side for the next two steps.
Attach the Top Pole (part 6) to the bottom of the board bracket (bottom two holes)
using the two Bolts, Nuts & Washers C (these are the thickest bolts). If not already
in place, put the Pole Top Cap (part 5) on the top of the Top Pole (part 6).
Attach Top Pole to Backboard Bracket
