installing Front Floor Pieces
6. Adjust the front seats to the rear most position to allow maximum clearance for installation. Place front
floor pieces into place. Tuck under console and around seat brackets as shown. (Fig. 2 and Fig. 3)
7. Once properly aligned, pull back part to access the three pieces of hook fastener (Fig. 4). Clean surface
with alcohol then remove the film backing and roll the part back into place. Firmly press the top surface
to ensure adhesive attachment. Repeat for other front floor piece.
FIguRe 2:
FIguRe 5:
FIguRe 3:
FIguRe 6:
FIguRe 4:
FIguRe 7:
installing MiD section
8. Adjust the front seats to the fully forward and tilted up (2-door passenger entry) position. Next place the
mid section into place. Position the mid section around seat brackets (Fig. 5 and Fig. 6) and tuck under
cupholder and console. (Fig. 7)
9. Once properly aligned, pull back part to access the four pieces of hook fastener. Clean surface with
alcohol then remove the film backing and roll the part back into place. Firmly press the top surface
to ensure adhesive attachment.
Jeep Wrangler Jk Bedrug/BedTred
Install Instructions
Jk
BEDRUG, INC.
n
635 Old Hickory Blvd, Old Hickory, TN 37138-3162
n
800-462-8435
n
bedrug.com
BR-BTJK07FINST
REV. 1 8/16/2013
Page 2 of 4