Technical data, mounting, wiring
PS1111-2402-0002
20
Version: 1.0
3.12
EMC
The power supply is suitable for application in industrial environments as well as in residential, commercial
and light industrial areas and small businesses.
The device complies with the following standards: EN 61000-6-1, EN 61000-6-2, EN 61000-6-3, EN
61000-6-4, EN 61000-3-2 and EN 61000-3-3.
This device complies with Part 15 of the FCC rules and operates under the following two conditions: (1) This
device must not cause harmful interference, and (2) this device must be able to handle any interference it is
subjected to, including interference that may cause undesired operation.
Do not use this device on an AC 100V mains supply with a load of more than 1.9A, if the application is
sensitive to a short circuit at the output, even with voltage drops during mains interruptions of less than
20ms.
EMC interference immunity
Strong transients
VDE 0160
Over the entire load range
750V; 1.3ms
EMC interference emission
According to the generic standards: EN 61000-6-3 and EN 61000-6-4
Conducted interference emission, input
lines
EN 55011, EN 55015, EN 55022,
FCC Part 15, CISPR 11, CISPR 22
Class B
Conducted interference emission, output
lines
2)
IEC/CISPR 16-1-2, IEC/CISPR
16-2-1
Limit values for the DC current connection accord-
ing to EN 61000-6-3 are met
Interference emission
EN 55011, EN 55022, CISPR 11,
CISPR 22
Class B
Harmonic input current
EN 61000-3-2
Class A requirements met
Voltage fluctuations, flicker
EN 61000-3-3
Met, tested with non-pulsating constant current
loads.
This device complies with FCC Part 15.
Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must be
able to deal with any interference received, including interference that may cause undesired operation.
Switching frequencies
Main converter
40kHz to 140kHz
Input load and output voltage dependent
