7650 BeckettLink Hub, Form No. 62203 Rev 0
—
11
10
—
7650 BeckettLink Hub, Form No. 62203 Rev 0
WiFi reset.
3
Follow the instructions in the
app for a WiFi reset.
4
Push the pin hole button on
the bottom of the hub once
to reset WiFi settings. Use a
pen or paperclip.
5
Yellow WiFi LED on the Hub
will flash 5 times quickly to
show WiFi reset has started.
6. Wait for the yellow WiFi LED
to turn off, this may take a
minute or more while WiFi
settings are cleared.
7. Once yellow WiFi LED
has turned off, press the
button on the
bottom of the WiFi Setup page
in the app.
8. Hub will begin scanning for
available WiFi networks.
Choose the desired network
and enter the correct
password. Apple (iOS)
phones must be connected to
the network you want to use
the hub.
Change WiFi Settings /
WiFi Reset
To update to a new WiFi router
or change WiFi password
1
Select the “Change WiFi
Settings” button at the
bottom of the Edit Hub
Settings page of the app.
2. Follow the instructions in the
app to change WiFi settings.
If the yellow WiFI LED continues
flashing it means registration of
the hub was not successful and
the WiFi reset should be used to
change the WiFi settings.
Remove or Change
Hub
To replace an existing or
faulty hub.
1
Select “Remove this Hub”
at the bottom of the Edit
Hub Settings page of
the app.
2
A warning will appear that
unregistering the hub will
also unregister all devices
associated with the hub.
3
Tapping on “OK” will
unregister the hub and
unregister all the devices
registered to the hub.
Start the setup and
registration process over with
the new hub. Redo the WiFi
network setup and enter the
WiFi password. Any devices
previously connected to the
old hub will need to be added
and paired to the new hub. If
a tank gauge is installed, you
will need to un-pair the tank
gauge (hold button on tank
gauge for 5 seconds, release,
hold button for another 5
seconds) before re-pairing
the tank gauge to the new
hub. A tank gauge can only
pair to one hub, so it cannot
pair to the new hub until it is
un-paired from the old hub.
Follow the instructions in the
BeckettLink® Tank Gauge
Manual 62202.
Using BeckettLink® App
Using BeckettLink® App
Edit Hub Settings
1
From the dashboard page tap
on the hub button.
2
On the hub detail page,
click the word ‘Edit” in iOS
apps or click on the pencil in
Android apps. The Edit Hub
Setting page will appear.
3
To edit or change the hub
name, tap on the hub name
and enter the new name then
tap “Save Changes”.
4
To activate the low
temperature warning, move
the slider (right) to the on
position and tap “Save
Changes”.
5
To change the low
temperature alert trigger
level, tap on the temperature
and enter the new
temperature then tap “Save
Changes”.
The allowed temperature
range for the low temperature
warning is 35° - 60° F (2° to
15°C). We recommend setting
the temperature at 45°F (7°C) or
above to allow for variations in
room temperature throughout
1
iOS
Android
3
2
3
4
5
1
1
4
5
2
3
