Instruction Manual
– Model AFG Oil Burner
3
Be aware of hazard definitions
Denotes presence of a hazard which, if ignored, will result in se-
vere personal injury, death or substantial property damage.
Denotes presence of a hazard which, if ignored, could result in
severe personal injury, death or substantial property damage.
Denotes presence of a hazard which, if ignored, could result in
minor personal injury or property damage.
Intended to bring special attention to information, but not related
to personal injury or property damage.
Notice special requirements
This equipment must be installed, adjusted and started only by a
qualified service agency
– an individual or agency, licensed and experienced
with all codes and ordinances, who is responsible for the installation and adjust-
ment of the equipment. The installation must comply with all local codes and
ordinances and with the latest revision of the National Fire Protection Standard
for Oil-Burning Equipment, NFPA 31 (or CSA B139-M91).
Read all instructions before proceeding
. Follow all instructions
completely. Failure to follow these instructions could result in equipment mal-
function, causing severe personal injury, death or substantial property damage.
Concealed damage
— If you discover damage to the burner or
controls during unpacking, notify the carrier at once and file the appropriate claim.
When contacting Beckett
for service information
— Please
record the
burner serial number
(and have available when calling or writing).
You will find the serial number on the Underwriters Laboratories label, located on
the left rear of the burner, or the cover mounting plate. See illustration below.
Check certifications/approvals
•
Underwriters Laboratories
has certified this burner to comply with ANSI/UL
296 and has listed it for use with #1 or #2 fuel oil as specified in ASTM
D396.
Low sulfur #1 and
#2 fuel oils reduce heat exchanger deposits
with all burners compared to the standard fuels.
Reduced deposits ex-
tend the service interval for cleaning and improve the efficiency of the
appliance over time.
Low sulfur fuels reduce particulate and oxides of
nitrogen emissions as well.
The Oilheat Manufacturers' Association rec-
ommends these fuels as the preferred fuels for this burner.
•
State and local approvals are shown on burner rating label (see below).
•
All oil burners should be installed in accordance with regulations of the
latest revision of the National Fire Protection Association
Standard NFPA 31
and in complete accordance with all local codes and authorities having juris-
diction. Regulation of these authorities take precedence over the general
instructions provided in this installation manual.
•
For recommended installation practice in Canada, reference to CSA Standard
B139-M91.
Prepare before installing
Verify specifications
