en
de
15
What to do if ...?
Problem
Cause
Remedy
Drive is not functioning.
Transmission control
light is on.
1. Receiver is outside
of the radio operating
range.
2. The SC861A has not
been programmed into
the receiver.
1. Reduce the distance
to the receiver.
2. Programme the
SC861A.
Drive is not running ,
LED is not illuminated.
Energy storage is
empty.
SC861A has to be char-
ged by sunlight.
Automatic control com-
mands are not carried
out.
The sliding switch of the
hand-held/wall trans-
mitter is set to manual
mode “
H
”.
Adjust the sliding switch
of the hand-held/wall
transmitter to automatic
mode “
S
”.
The system does not au-
tomatically extend when
should the sliding switch
be set to “
S
”.
1. The sunlight thresh-
old value has not been
reached.
2. The wind thresh-
old value is has been
exceeded.
1. Adjust sunlight
threshold value using
the transmitter.
2. Wait until wind
abates.
The system does not
extend in response to a
manual command when
the sliding switch is set
to “
H
” or “
S
”.
The wind threshold
value of the transmitter
has been exceeded.
Wait until wind abates.
Subject to technical changes without notice.