GT6201
_________________________________________________________________________________________
DV 17001.03 Issue 4 01/2015
Page 23
Display Contents
Description
During signal reception on the “ACTIVE FREQUENCY”, a switch
over to the “PRESET FREQUENCY” is not possible. The audio
remains on “ACTIVE FREQUENCY” and a short beep tone is
audible. Additionally the “PRESET FREQUENCY” will appear
contrast inverted in a sequence of approximately one second.
FREQ CHANGE BEEP
- if selected the transceiver generates a
short beep on each change of the “ACTIVE FREQUENCY”.
SWAP MIKE IC
- if selected the /IC input functions as /MIKE_SW
input and /MIKE_SW input operates as /IC input.
On “AUX IN SENS” page the sensitivity adjustment of the
auxiliary audio input (Pin P1-4 / Pin P1-21), in the range 50mV to
8000mV, can be set by turning the “ROTARY ENCODER”.
This page is displayed only if ENABLE_AUX_IN is activated.
The VU meter shows the current signal level of the aux audio
input and always displays the highest detected signal value from
the last 3 seconds.
Note:
Menu available on primary controller
.
On “AUTO AUX ATT” page the attenuation for the auxiliary
audio input can be adjusted between 0 to 40 dB by turning the
“ROTARY ENCODER”.
When intercommunication is initiated (regardless of the intercom
activation: “VOX”, or “/IC” discrete input) the signal from auxiliary
audio input will be attenuated. After intercommunication is
finished the auxiliary audio will revert to its previous level.
Note:
Menu available on primary controller
On “IN/OUT CFG 1” page the microphone inputs and
headphone outputs for configuration CFG1 can be configured.
To scroll the page turn the “ROTARY ENCODER”.
“MICROPHONE 1” (one option can be selected at one time
only):
STD1 MIKE
- standard microphone input 1 (Pins
P1-18/ P1-8) is selected.
STD2 MIKE
- standard microphone input 2 (Pins
P1-9/ P1-8) is selected.
STD3 MIKE
- standard microphone input 3 (Pins
P1-19/ P1-8) is selected.
DYN MIKE
- dynamic microphone input (Pins
P1-6/ P1-5) is selected.
NONE
- No microphones is used in microphone path 1.
“MICROPHONE 2” (one option can be selected at one time
only):
STD1 MIKE
- standard microphone input 1 (Pins
P1-18/ P1-8) is selected.
STD2 MIKE
- standard microphone input 2 (Pins
P1-9/ P1-8) is selected.