Intended use
The type of tubular drive described in these instructions is intended solely for the operation of roller shutter systems with fixed
stops in both limit positions using rigid shaft connectors. The crank handle is intended to be used for convenient manual operation
only
in the event of a power failure
. Continuous operation or use of tools (e.g. drilling machines for activation of the crank
handle) is prohibited as, after a certain amount of time, this leads to loss of manual function and with it the tubular drive.
For sun protection, please only use the types of tubular drive specifically designed for this purpose.
This type of tubular drive is designed for use in single systems (one drive per barrel).
The tubular drive must not be used in potentially explosive areas.
The connecting cable is not suitable for transporting the drive. Always carry the drive by the housing tube.
Other applications, uses and modifications are not permitted in order to protect the safety of the users and others, since these ac-
tions can impair the system’s safety and carry the risk of personal injury and property damage. The drive manufacturer does not
accept liability for damages or injury arising from such actions.
Always observe the information in these instructions when operating or repairing the system. The drive manufacturer does not ac-
cept liability for damage or injury resulting from improper usage.
Attention
In the lower limit position it must not be possible to bend between the lath and shaft con-
nector or between the uppermost laths. Otherwise the joints could be subjected to too
much stress and could become damaged.
Drive version with angled plug
Assembling the plug-in connecting cable for tubular drives with angled plug
Insert the
dead
connecting cable into the angled plug until the locating lug clicks into place in the angled plug. If necessary, use a
suitable flathead screwdriver to assist with insertion. Set the screwdriver into one of the two grooves on the plug-in connecting
cable provided for this purpose.
Check that the cable is properly engaged.
1
1 = locating lug
6 - en