Programming the run times
Note
Programming of the run times is only possible with
transmitters which support the function "MemoCon‐
trol".
Each receiver can save one switching time for one UP and one
DOWN cycle.
In the “ ” slide switch position, this roller shutter action is repeated
every 24 hours.
It does not matter what position the / slide switch is in when
programming the switching time. Any stored switching times are
overwritten.
1. If necessary, run the roller shutter to the opposite limit position.
2. Wait for the time you wish the automatic drive command to be exe‐
cuted.
3. At the desired time, press and hold the relevant direction button
until the roller shutter drive briefly stops after approx. 6 seconds
and then continues to the limit position.
4. Release the direction button.
The receiver has saved the current time for this direction of travel.
en
31
Summary of Contents for Centronic VarioControl VC120
Page 72: ...4034 630 127 0b 03 07 2012...
