Becker BXP6401-1 Series, Installation And Operational Manual

Page: 45 / 50

Negative results are indicated on the display with “FAILURE”. The transponder
may be not switched into ON or ALT mode if any failure was found.
The PBIT takes not longer than 1 second. If the test was successful, the XPDR
switches immediately into the normal operating mode.
Fig. 3-6 Error indication and Warning indication
G. Selection mode
Press SEL button (G) and rotate encoder (B) for selection. In selection mode
additional information is displayed in the bottom line of the display. Some of
the data are editable, some are read only:
VFR 4096 code presetting editable; see section G.2
AI Aircraft Identifier fixed; read only from address mo-
(Tail Number) dule (can be replaced by FN)
If no valid AI is stored, “--------”
is displayed.
FN Flight Number or editable; see section G.1,
Company Call Sign can be replaced by AI (fixed) by
selecting “AI DEF”
AA Aircraft Address fixed; read only from address
(24-bit ICAO) module (unique number for each
aircraft)
MA Maximum Airspeed fixed; read only from address
module
AT Aircraft Type fixed; read only from address
module
CFG Configuration available in SBY mode only,
see section L
INS Installation setup available in SBY mode only;
protected by password,
see chapter 2, section 8
INSTALLATION AND OPERATION BXP6401-X-(XX)
Page 3-5
34-50-08
September 2011