3
INWEIS
H
The communication between the smartphone
and the KNX devices is established via Blu-
etooth. This function can be switched off via
the ETS (the function is always pre-set in the
factory to "On").
During parameterisation, change the default
password in accordance with your specifica-
tions and memorise your password in order to
prevent operation by unauthorised persons.
ARNUNG
W
Never randomly press the push button on
the app without having a line of sight to the
sun shading system.
Fig. 2
Smartphone app
The manual override operation, a push button on the
device, has the highest priority and overrides all KNX com-
mands (even the safety objects).
The operating behaviour corresponds to the "KNX behavi-
our":
Brief push of the button = Stop
Long push of the button = Move
WARNING
Never randomly press the buttons on the
keypad without having a line of sight to
the sun shading system.
Programming
You can perform programming either in the app or directly
on the device.
There is a Prog button for programming and a display LED
both in the app and on the keypad (see Fig. 3).
The procedure here is basically the same:
Press the programming button in the app or on the
device (Fig. 3) to put the device into programming
mode. The red LED lights up when programming mode
is active. Programming is performed using the ETS on
the PC. This software ends the programming mode
automatically. The red LED goes out.
If the programming mode is to be ended earlier, press
the programming button again. The red LED goes out.
Fig. 3
Cover plate
LED flash patterns
Communication
LED green
Error
LED
red
Statement
Flashes
irregu-
larly
X
SMI communication,
no fault
Flashes
irregu-
larly
X
SMI communication,
faults occur (the LED
is deactivated during
the motor search &
initialisation)
Lights
up con-
stantly
X
X
Unparameterised - SMI
bus not yet commissi-
oned or no motors in
the internal motor list
Maintenance
There are no parts inside the device that require mainte-
nance.
Liability
Failure to comply with the product information in these
instructions and any use of the device other than its inten-
ded use may result in the manufacturer refusing to honour
warranty claims for product damage. In this case, liability
for secondary harm to persons or damage to property will
also be excluded. Observe the information in the operating
instructions for your sun shading system. The automatic
or manual operation of the sun shading system while iced
over and the use of the sun shading system during severe
weather may cause damage and must be prevented by
the operator through suitable precautions.
Disposal
After use, the device must be disposed of according to
legal regulations or turned in to your local recycling centre.
Summary of Contents for 3TE 16K BT
Page 6: ......
