20
Your dishwashers are designed to use liquid rinse aids. The rinse aid
dispenser is located inside the door next to the detergent dispenser.
To fill the dispenser, open the cap and pour the rinse aid into the
dispenser until the level indicator turns completely black. The volume
of the rinse aid container is about 140 ml. Be careful not to overfill the
dispenser, as it could cause excess suds. Wipe away any spills with
a damp cloth. Don’t forget to replace the cap before you close the
dishwasher door.
Attention!
Clean up any rinse aid split during filling with an absorbent cloth to
avoid excess suds during the next wash.
Adjusting Rinse Aid Dispenser
The rinse aid dispenser has four or six settings.
Always start with the dispenser set on “4” If
spots and poor drying are problems, increase the
amount of rinse aid dispensed by removing the
dispenser lid and rotating the dial to “5”. If the
dishes still are not drying properly or are spotted,
adjust the dial to the next higher number until
your dishes are spot-free. The dose is factory set
in the position 5.
Note:
set the rinse aid dispenser to a higher dosage if there are drops
of water or lime spots on the dishes after washing. Reduce it if there
are sticky whitish streaks on the dishes or a bluish film on glassware or
knife blades.
D. Detergent
Detergents with its chemical ingredients are necessary to remove dirt,
crush dirt and transport it out of the dishwasher. Most commercial
quality detergents are suitable for this purpose.
