BecherAir Components BECMATIC 550, Owner'S Manual

Page: 13 / 17

13
TROUBLE SHOOTING
PROBLEM CAUSE SOLUTION
No Power Check power source, restore
as necessary
Fuse Blown Remove Base Panel, replace
inline fuse
Unit
will not operate,
ON/OFF, Switch does not
light.
Faulty Switch Replace On/Off Switch
No air to unit Restore air supply
Timer not cycling Replace timer
Unit will not operate –
ON/OFF Switch is lit
Air valve not shifting Replace air valve
Nozzle obstructed Remove and clear nozzle
Springs oversized or
damaged
Replace springs
Inadequate air supply Restore supply to 80 p.s.i.
Air leaking around door(s) Adjust door latch/replace
gasket
Unit runs – will not feed
springs
Window(s) leaking Replace windows
Supply reservoir over filled Remove springs to restore
operating level
Unit
runs
– feed rate
inadequate Insufficient volume in supply
reservoir Add springs to restore
operating level
Feed tube kinked, worn or
obstructed Replace feed tube
Springs have been
magnetized
Remove and degauss springs
Springs dirty or oily Remove and clean springs
Springs will not feed down
tube
Static charge Small, light springs are
subject to static charge
buildup. This may become
worse
in low humidity
conditions. An occasional
shot of anti-static aerosol can
eliminate this problem. Take
care to not saturate the
springs. Any liquid – water,
oil or solvent will impair
spring feed rates.