-31-
Dynamic MAC Table
Static MAC Table
MAC Filtering
Dynamic MAC Table
The switch will dynamically learn the device’s MAC address when it
corresponding with the switch. MAC address will be stored in MAC address
table. Dynamic MAC Table shows the MAC addresses learned by the switch.
The table will be shown by pages if larger than 500 MAC Addresses. You can
set the age-out time of Dynamic MAC table in switch setting:
Click Clear to clear Dynamic MAC address table.
Click Top to show the first page of MAC address table.
Click Prev to show the previous page of MAC address table. If there is
nothing to shown or NO is 1, it is the first page.
Click Next to show the next page of MAC address table. If there is nothing
to shown, it is the end page.
Static MAC Table
When you add a static MAC address, it permanently remains in the switch's
address table, regardless of whether the device is physically connected to the
switch. This saves the switch from having to re-learn a device's MAC address
when the disconnected or powered-off device is active on the network again.
This table can associate with the Security field in Port Controls configuration to
achieve the access control by source MAC / port / VID binding. That is only
ingress traffic with matched lookup (with specified MAC address, port number
and VID) in this table can be allowed to access to the switch.
The following parameters can be associated to setup the Static MAC table:
MAC Address:
Static MAC address in a MAC entry
