®
BCR130/5-BCR164/6,5-BCR300/12
BEAST CORE RIG OPERATING MANUAL
13
OVER HEAD DRILLING
DANGER: When drilling “over” head
always secure the drill stand with
the assembly.
DANGER: When drilling “over”
head, always use a water collecting
ring and a industrial wet-type vacu-
um cleaner!
Mounting the water collecting
ring 34
•
Loosen the fixation screw
33
on the water
collecting ring
34
.
•
Push the water collecting ring
34
onto the
drill stand and press it firmly against the
material to be drilled.
•
Tighten fixation screw
33
.
•
Connect a industrial wet-type vacuum
cleaner.
•
When using the water collecting ring,
attach a protective cover
32
onto it and drill
through. Remove te drilled part of the cover
32
from the core bit.
TRANSPORT AND STORAGE
CAUTION: Danger of injury and
damage! Pay attention to the
weight of the appliance when
transporting it.
•
Clean the machine and remove the drilling
dirt.
•
Transport the machine and core bit sepa-
rately.
•
Blow out remaining water from hose and
machine when it freezes.
•
This appliance may only be stored inside a
building.
MAINTENANCE AND CLEANING
Clean the machine with water and a brush after
use and lubricate the moveable parts as well as
the rack with a silikon spray.
Always keep the machine and cooling air vents
free and clean. It must always be kept in a dry,
frost-free place.
Clean the filter of the vacuum pump
The condition of the filter must be checked at
regular intervals.
•
Loosen the four screws with hexagonal recess
on the bottom of the frame
46
.
•
Unscrew filter cover
39
.
•
If necessary, renew filter parts.
•
Screw on filter cap
39
again. The arrows on
the cap must point in the direction of flow of
the sucked in air.
•
Mount the pump on the frame
46
again.
TROUBLESHOOTING
For malfunctions that are not specified in this
chapter, when in doubt or when explicitly indi-
cated, seek assistance from an authorized service
facility.
