BEARWARE 304475, Manual

Page: 14 / 48

14
English
5. Initial use
Take the device out of the package and remove all the packaging material. Insert
one "CR2032" batteries into the battery compartment on the rear side. Pay atten -
tion to the correct polarity of the contacts. This battery is used for saving a backup
of the time and alarm.
6. Setting the time
Once the device is connected to a properly installed socket, press and hold the "SET"
button for about 3 seconds to adjust the time. Use the "UP" and "DOWN" buttons to
increase or decrease the values. Press "SET" once again to continue with the settings.
The setting cycle is as follows:
1. Hour
2. Minute
3. 12/24 Hours
4. Snooze time (select a snooze time from 5 minutes to 60 minutes)
Press the "SET" button to complete the settings, or wait for about 20 seconds.
Note: If you have selected the 12-hour display, the "PM" LED is displayed at the
corresponding times.
Number Name
1 Operating controls
2 Time display
3 Stand
4 "DOWN” button
5 "VOL” button
6 “Radio/Sleep" button
7 "SNOOZE/DIMMER" button
8 "SET" button
9 "AL” button
10 "UP” button