BASKET HOOD ASSEMBLY
SUPPLIED:
SUPPLIED: Folding Hood, 2 x Plastic Ribbing, 2 x Screws, 2
x Wing Nuts, 4 x Spacers.
•
• STEP 1:
STEP 1:
On the under side of the hood
you will find 2 small sleeves where the
plastic ribbing is to be inserted.
• • STEP 2:
STEP 2:
Slide one piece of the plastic
ribbing through sleeve until it reaches
the other side of the hood. Repeat with
second piece or ribbing (FIG.1 & FIG 2)
• • STEP 3:
STEP 3:
Take the screw and spacer and
push outwards (from inside to outside)
through the shnuggle near shnuggle
handle. (FIG.3)
• • STEP 4:
STEP 4:
Once both pieces of ribbing
have been inserted and pulled through,
match up the screw holes. Place the two
pieces of plastic ribbing over the screws
you have just inserted. (FIG.2 & FIG 4)
• • STEP 5:
STEP 5:
Slide on second spacer and
screw the wing nut into place. Tighten as
desired. Repeat on other side. (FIG.5)
• • STEP 6:
STEP 6:
Bring both elastic loops down
and secure them over the wing nut and
screw. (FIG.5)
• • STEP 7:
STEP 7:
Tie to cotton bumper up over the
wing nut and screw. (FIG.6)
• • STEP 8:
STEP 8:
Pull elastic hood over the back
of the shnuggle.
FIG. 1
FIG. 1
FIG. 2
FIG. 2
FIG. 3
FIG. 3
FIG. 4
FIG. 4
FIG. 5
FIG. 5
FIG. 6
FIG. 6
10
BASKET & LINEN ASSEMBLY
1. Remove plastic from mattress, place
fitted sheet on it and place inside the
Shnuggle.
2. Take the silver insulation & cooling pad
from the blue Cuddle Cot box. Place the
silver insulation on top of the mattress.
Use double thickness and place the
silver side upwards.
11
Bears Of Hope
Bears Of Hope
- CUDDLE COT PACKAGE & ASSEMBLY
FOR CUDDLE COT USE ONLY.
FOR CUDDLE COT USE ONLY.
