carriage assembly onto the column by
orienting it horizontally while passing
the upper rollers through the rail
cutouts located near the bottom. Then
raise it up and pass the lower rails
through the cutouts. Lift it up the
column and attach the carriage tie
strap to its upper loop.
10.
Place a 1”-2” spacer block on the
column leg beneath the carriage so that the carriage can’t go low enough for
the lower rollers to pop out of the cutouts in the rails.
11.
Position the dirt bike to be loaded as in step 2 above and lean the handlebar
against the wall. Then lower the carriages with the hoist until you achieve
the desired spacing between the bikes. Insert the Motono Platform into the
receiver as before and then from the back side lift the carriage by hand
while removing the slack from the carriage tie strap.
12.
Continue as in steps 4-7 above.
13.
Hint: Once you have found the correct location for loading bike/s, marking
the floor can make loading the bike/s simpler next time.
14.
Hint: An organized person might install hooks on the wall near their
Ascension Minimalift to conveniently hang carriages and platforms as they
are removed from the lift.
4.
CAPACITY
The Motono Platform is rated for 400lbs