- 6 -
Remote Level Control
Connect the remote control to the connector on the back of the fogger. After warm-up, the LED will light up to indicate
that the machine is ready for use. Use the switch to turn on / turn off the fog machine pump and use the dial to adjust
the output volume from 0 ~ 100%.
DMX control (DIP)
Connect the device directly to a DMX controller or a DMX loop with multiple DMX effects. The machine has a 3-pin
XLR connector for DMX connection.
Address not selectable, address is always 1.
Note:
It is necessary always lock a DMX loop with a 120 Ohm terminator for correct data transmission.
CHANNEL
VALUE
FUNCTION
1
0
– 100%
Snowlevel
2
0
– 100%
Airlevel (Ch1 must be on)
Timer remote control
Connect the remote control to the connector on the back of the fogger.
After some warm-up time, the device is ready for use, the LED will light up on the remote. During use, it may happen
that the machine stops, in this case the LED will go out, indicating that the machine is warming up.
Timer function:
Press the yellow button and set the interval, duration and volume controls to the desired level.
Interval: time between the smoke moments (10-200 seconds)
Volume: amount of smoke (0-100%)
Duration: duration of the smoking time
Continuous function:
Press the red button and set the volume to the desired level. The machine will continuously produce an amount of
smoke. It may be that the machine in between have to warm up, during this period no smoke is produced. How many
times this is done depends on the amount of smoke.
Manual Mode:
Press the green button to produce 100% smoke immediately; this button overrides all previous settings.
Specification
Power supply ................................................. 220-240VAC, 50Hz
Tank capacity ................................................................ 3.1 litres
Dimensions ................................................... 470 x 255 x 270mm
Weight ................................................................................ 7.3kg
Accessories
Snow fluid, high quality on water basis, specially designed for the Beamz snow machine. Is used undiluted and
guarantees trouble-free operation. 1 litre pack, Ref no. 160.578 .
Do not attempt to make any repairs yourself. This would invalid your warranty. Do not make any changes to the unit. This would
also invalid your warranty. The warranty is not applicable in case of accidents or damages caused by inappropriate use or
disrespect of the warnings contained in this manual. Tronios BV cannot be held responsible for personal injuries caused by a
disrespect of the safety recommendations and warnings. This is also applicable to all damages in whatever form.
Electric products must not be put into household waste. Please bring them to a recycling centre. Ask your local
authorities or your dealer about the way to proceed.
