4
HOW TO CONTROL THE UNIT
Four ways to operation:
A. Master/Slave operation
B. Easy sound active and Auto mode
C. Universal DMX controller
D.IR remote control Master/Slave operation
The unit can be linked together in daisy chain as many as you need in master/slave mode to perform the great built-in pre-
programmed lighting shows triggered by music.
In Master/Slave mode refer to the DMX settings below:
Master unit
: when working at
Auto-run
or
Sound
Control mode operation
Slave units
: DMX start address MUST be set to d001.
DMX-512 CONNECTION
If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX input of the
first unit in a DMX chain. Always connect the output of one unit with the input of the next unit until all units are connected.
If you use a controller with 5 pin DMX connection you will need to use a 5-pin to 3-pin adapter.
At the last fixture, the DMX cable has to be terminated. Solder a 120 Ohm resistor between signal (-) and signal (+)
into a 3-pin XLR connector and plug this into the DMX output of the last fixture in the chain.
IR REMOTE CONTROLLER INTRODUCTION
BLACK OUT
:
setting On / Off (return the present program)
DMX
:
Press
DMX
mode, setting DMX address from the digits button.
Example setting adress 017, press DMX, press 0, press 1 and press
7.
COLOR
: Press color setting mode, setting different color from the
COLOR
button.
SOUND
:
Press
SOUND
mode, setting different sound mode from the digits
button.
SPEED
: Press
SPEED
mode, setting different speed mode from the digits
button mode only uses under
AUTO
or
SOUND
mode. And no fit for
the other mode.
FLASH
: Press FLASH mode, setting different FLASH mode from the digits
button 1 to 10 digits.
DIMING MODE
: Press
= Up
or
= Down
setting brightness
With 255 different levels for all color.