Ch. 1 Introduction
Remote Unit Installation
Installation Overview
Service Utilities
8
Pre-Production
1106333-01
Revision 3
Installation Overview
This section overviews the installation steps for the BRU-150 and BRU-100
remote units.
BRU-150 Self-Install Remote Unit
The BRU-150 is designed for the subscriber to self-install the unit.
However, for system release 1.1 the configuration process has not been fully
automated. You must manually set the Local RUID (remote unit
identification) before delivering the unit to the subscriber. This parameter
uniquely identifies this remote unit to the base station.
Prior to sending the remote unit to a subscriber, you must determine the
Local RUID that will be assigned to this unit. Your company should have
developed a plan for Local RUID assignment.
Note
:
The Local RUID is normally associated with a particular
subscriber. You must ensure the correct BRU-150 is being
delivered to a subscriber based on the Local RUID assignment.
The Local RUID is configured into the Transceiver of the BRU-150 with
the BRUIT (installation tool). At Step 3 in the BRUIT you will open the
BRU Configuration window and set a value for the Local RUID.
The subscriber will use the BRU-150
Installation Quick Guide
to
accomplish the installation. If a subscriber is in an area with difficult
reception, you may need to make a service call to perform a manual
installation using precise antenna-pointing techniques.
BRU-100 Professional Install Remote Unit
The installation process for the BRU-100 is described in detail in the
installation documents listed in the following section. The service utilities
are used in place of the RIT (Remote Unit Installation Tool) currently
described in those documents.
