Beam RemoteSAT RST100B, Installation And User Manual

Page: 20 / 40

RST100B INSTALLATION & USER MANUAL
20
Connecting to the Log Port
1. Plug the laptop cable into the Log Port of the RST100B.
Made in Australia
Antenna
Power Input
11-32V DC
Remote Status Indicator
Accessory Line Handset
Comm Port
Log Port
Reset
Figure: Serial cable connected to Log Port
The Log Port should only be used for configuration and control of the
terminal equipment. The Log Port cannot be used for communications or
data services.
The Log Port can also be used when using a Beam Alert/Monitoring Device , refer to the
instruction provided with the accessory device for configuration and installation.
Connecting an Antenna Cable
1.
Plug the antenna cable into the antenna jack located on the rear panel of the
RST100B, as shown below. Secure this cable by tightening the connector collar.
2.
The specified cable being used must not exceed the Iridium 3dB maximum loss
rating. This will ensure maximum performance of your RST100B.
Refer to your Service Provider for full details or to purchase an approved cable.
Made in Australia
Antenna
Power Input
11-32V DC
Remote Status Indicator
Accessory Line Handset
Comm Port
Log Port
Reset
Figure: Antenna cable connected to a RST100B