6
Beach House – Water Filter Systems, Ring, Clonakilty, Co. Cork, Ireland
Faucet & Storage Tank
Installing the Faucet
The product water faucet may be installed on any flat surface at least 2’’ in diameter. Check the
underside of the location for interference.
Stainless Steel Sink
Make a small indent to mark the desired drilling
location using a centre punch. Drill a pilot hole
with a 1/8’’ metal drill bit. Enlarge the hole
using a 1/2’’ metal drill bit.
Faucet installation
Once the hole has been drilled in the sink, the
faucet may be located in the hole. Be sure the
faucet body, faucet base, and the rubber
faucet base washer are in place above the
sink.
Install the star lock washer and nut, then
tighten firmly while aligned faucet in the
desired direction.
Additional Point of Use Connection
To connect an additional point of use
(icemaker, extra faucet, etc.) place a T-
connector in the ¼’’ line between the faucet
and the RO system.
NOTE:
Icemakers typically use ¼’’ tubing as
the water feed line. Use a reducing union fitting
to make this connection.
Mounting the Tank Ball Valve
NOTE: Do not tamper with the air valve on the storage tank. It has been preset and
screwed on with blue cap by the manufacturers.
Assemble Hardware as shown:
1. Wrap the threads on the top of the water
storage tank 3 times with plumbers (teflon)
tape only. Make sure it is tight, but not over
tight.
2. Connect the tank ball valve assembly to the
top of the water storage tank.
3.
Connect the tube from the RO module to
the water storage tank.
