BEA PHOENIX EX, Quick Start Manual, Page: 3 / 8

X
X
75.5863.04 PHOENIX EX 20210701 Page 3 of 8
red
red
red
red
red
green
off
off
x = number of flashes = value of parameter
LED flashes quickly LED flashes LED flashes slowly LED flashes x times
LED is off
LED SIGNALS
HOW TO USE THE REMOTE CONTROL
ADJUSTING ONE OR MORE PARAMETERS
CHECKING A VALUE
The access code (1 to 4 digits) is recommended to set sensors installed close to each other.
Once you have saved an access code, you always need to enter this code to unlock the sensor.
If you forget the access code,
cycle the power . For the first minute, you can access the sensor without an
access code.
SAVING AN ACCESS CODE
DELETING AN ACCESS CODE
DELETING AN UNKNOWN ACCESS CODE
START/END AN ADJUSTMENT SESSION: press and hold either push button until the
LED flashes or stops flashing
SCROLL THROUGH PARAMETERS: press the right push button
CHANGE VALUE OF CHOSEN PARAMETER: press the left push button
RESET TO FACTORY VALUES: press and hold both push buttons until both LEDs flash
HOW TO USE THE PUSH BUTTONS
ACTIVITY
none = no detection
COLOR INDICATIONS
red = detection
red/green = power on / learn
You must unscrew the explosion-proof cover to access the push buttons.
To do so, loosen the set screw and then unscrew the lid.