BEA JAMB CAM User Manual Download Page 3

75.5779.01 JAMB CAM 20131115   

Page 3 of 4

INSTALLATION

NOTE:  Make sure power is OFF before installing jamb cams

1)  Determine mounting location and apply mounting template to jamb

NOTE:  For best results, horizontal center line of mounting template should be 54’’ from 

ground

2)  Predrill two (2) 1/8’’ mounting holes and one (1) 1 1/4’’ camera hole

3)  Determine appropriate camera orientation and mount camera into housing

NOTE:  If mounting on LEFT jamb, camera wire should lead towards housing window 

(out of housing) and if mounting on RIGHT jamb, camera wire should lead away from 

housing window (into housing)

4)  Plug camera into power/video harness

5)  Route power/video harness up jamb into door header

6)  Connect RCA video out from power/video harness into appropriate RCA video in

7)  Wire nut red and black power wires to external transformer

8)  Fasten housing onto jamb with supplied screws

NOTE:  If mounting in exterior application, apply a bead of silicone caulk to back of 

housing

Power

Supply

RCA Video 

Out (female)

Power In

(see specs)

Camera/Harness

JST

Summary of Contents for JAMB CAM

Page 1: ... Phillips 0 Phillips 2 1 8 Drill Bit 1 1 4 Drill Bit Multimeter Caulk Caulking Gun COMPONENTS REQUIRED TOOLS DESCRIPTION PART NUMBER CMOS Camera 12 1000 2 5 mm Lens 50 5277 Power Video Harness 20 5316 Housing 70 5528 Housing Screws 50 1818 Camera Screws 50 5276 User s Guide 75 5779 Mounting Template 75 5780 1 camera 2 housing 3 power supply video harness 1 2 3 ...

Page 2: ...n of installation DO NOT attempt any internal repair of the components All repairs and or component replacements must be performed by BEA Inc Unauthorized disassembly or repair 1 May jeopardize personal safety and may expose one to the risk of electrical shock 2 May adversely affect the safe and reliable performance of the product resulting in a voided warranty PRECAUTIONS The device should not be...

Page 3: ...unting on LEFT jamb camera wire should lead towards housing window out of housing and if mounting on RIGHT jamb camera wire should lead away from housing window into housing 4 Plug camera into power video harness 5 Route power video harness up jamb into door header 6 Connect RCA video out from power video harness into appropriate RCA video in 7 Wire nut red and black power wires to external transf...

Page 4: ...bel prior to putting the equipment into operation A AADMAmerican Association of Automatic Door Manufactures ANSI AAADM Compliance TECHNICAL SPECIFICATIONS Power Supply 6 6 36 VDC 10 6 28 VAC 10 Operating Temperature 30 to 60 C RH 95 max Video Output 1 0 Vp p 75Ω Image Sensor CMOS Horizontal Resolution 480 TVL NTSC Output 720 H x 480 V Sync System Inter Sync Frame Rate 30 fps Minimum Illumination 0...

Reviews: