1
1
1
1
1
BEA SA
| LIEGE Science Park | Allée des Noisetiers, 5 - 4031 ANGLEUR [BELGIUM] | T +32 4 361 65 65 | F +32 4 361 28 58 | [email protected] | www.beasensors.com
©
B
EA
|
O
ri
gi
na
l i
ns
tr
uc
ti
on
s
|
47
.0
02
8 / V
3
-
0
4.
21
-D
0
BEA hereby declares that the FLY is in conformity with the basic requirements and the other relevant provisions of the
directives 2014/30/EU and 2011/65/EU.
The complete declaration of conformity is available on our website.
TROUBLESHOOTING
Only for EC countries: According to the European Guideline 2012/19/EU for Waste Electrical and Electronic Equipment (WEEE)
INSTALLATION TIPS
The sensor must be firmly
fastened in order to avoid
vibrations!
When mounting the Fly,
make sure you apply the
brackets before tightening
the screws.
When clipping the sensor
on the FCA, make sure you
apply the washers before
tightening the screws.
Always use the aluminium
screws to fasten the
accessories and the black
screws to fix the sensor!
Using the wrong screws
could damage the sensor!
PRODUCT RANGE & ACCESSORIES
The door remains
closed. The LED is OFF.
The door will not open
and the LED lights up.
The door opens when
no detection occurs
and closes during
detection.
The sensing field does
not correspond to your
requirements.
The detection is very
bad.
The sensor power is off.
The mode of the relay output
is not correct.
The cut of the masking lens
is wrong.
The sensor might be installed
upside down.
The wiring of the relay
output is not connected
correctly.
Check the wiring and the power supply. check the
supplied voltage.
Check the relay wiring.
Change the position of dip-switch 2.
Cut out a new lens to meet the required sensing
field size.
Check if the sensor is installed with its connector
facing you.
Main cable 2.5m
FLY
FCA: Fly Ceiling Accessory
FSA: Fly Surface Accessory
FLYCATCHER:
Kit for mounting on wall
FLYUP
: Kit for mounting in ceiling
FLY
