BE Power Equipment HW2765HG, Operator'S Manual

Page: 11 / 102

BEPOWEREQUIPMENT.COM 11
START-UP (COLD WATER)
To start your pressure washer for the first time, follow these instructions step-by-step. This starting
information also applies if you have let the pressure washer sit idle for at least a day.
1. Make sure the unit is level and placed on solid ground. Ensure the wheels are locked so that it doesn't
move during operation.
2. Connect garden hose to water inlet on pressure washer pump. To do this, thread the end of the hose into
the inlet by hand until tight and secure.
3. Attach wand extension to spray gun. Tighten by hand.
4. Choose desired spray tip, pull back nozzle extension collar, insert spray tip and release collar. Tug on
spray tip to make sure it is securely in place. See Spray Tips on page 9 for more information.
NOTICE
DO NOT run the pump without the water supply connected and turned on. Failure to follow this rule
will result in damage to the pump. Damage caused by running the pump without water is
not covered by warranty.
5. Pull down on the collar of the quick-connect coupler, slide onto the gun connector and let go of collar.
Pull on hose to ensure the connection is tight.
OPERATION