Be Cool BC10MBKL2101F, Operator'S Manual

Page: 64 / 72

The air conditioner The unit is not straight. Use a spirit level to check the unit is
is leaking. horizontal, if not remove from the wall
and Straighten.
The drain pipe is blocked. Check the drain pipe to ensure it is
not blocked or constricted.
Compressor does Overheat protection operational. Wait for 3 minutes until the
not work. temperature is lowered, and then
restart the machine.
The remote The remote control is not aligned Let the remote control get close to
control does with the direction of the remote- the air conditioner, and make sure
not work. control receiver. that the remote control directly faces
to the direction of the remote-control
receiver.
Batteries poor. Replace batteries.
If problems not listed in the table occur or recommended solutions do not work, please
contact the service centre.
ERROR CODES
Fault Code Fault Description Fault Code Fault Description
F1 Compressor IPM error P5 AC undervoltage protection
F2 PFC/IPM error P7 Defrost protection on coil tube
F3 Compressor start error P8 Zero-crossing fault detection
F4 Compressor running out of step PA
Return air sensor temperature
abnormal protection
F5 Location detection loop failure PE Abnormal refrigerant circulation
F6 PCB communication error PH Exhaust temperature protection
F8 Sensor on suction pipe error E0 Sensor on suction pipe error
FA Phase current overcurrent protection E1 Temperature sensor error
FL Water-full protection E2 Sensor error on indoor coil tube
P1
Over-heat protection on top of
compressor
E3 DC fan Feedback failure
P2 Dc bus voltage Undervoltage protection E5 Water-splash motor error
P3 AC Input voltage protection E8 Fan feedback fault
P4 AC over-current protection EE EE error