8
LB55 USER MANUAL
Figure 4
E
A
B
C
D
D
C
Install handle bar
1. Fix the handle rod (A) and (B) with M8x45 flange
bolt (D) and M8 flange loosening nut (C).
2. Fix the assembled handle rod (A & B) and base
(E) with M8x45 flange bolt (D) and M8 flange
loosening nut (C). (See Figure 4).
OPERATION CHECK LIST
1. Review and follow all safety rules and safety decal instructions.
2. Check whether the guard, impeller and housing are damaged. Replace or repair them before operation.
3. Check to make sure all parts are properly installed and in good condition.
4. Check the cooling device on the engine, governor components and mufflers are working well. Please
check the air filter and replace it if necessary.
5. When filling the fuel, please do not overfill. Please refer to the engine manual.
BEFORE STARTING THE ENGINE
1. Be familiar with the controls, how each function, and what each operates.
2. Check engine oil level. Add oil if necessary, following the engine manufacturer’s recommendations. Refer
to engine manual included with literature packet.
3. Check the air cleaner for dirty, loose, or damaged parts. Clean or replace if necessary.
4. Check the air intake and cooling area for dirt or debris and clean as necessary.
Notes: Fill fuel tank with good quality, clean, unleaded regular gasoline to the level recommended by the
engine manufacturer. BE SURE to install fuel cap after refueling.
TO CHECK OR ADD FUEL
1. Use a funnel to avoid spilling.
2. Do it outdoors.
3. Do not smoke.
4. Stop the engine; allow to cool.
5. Do not overfill.
6. Clean up spilled fuel.
STARTING THE ENGINE
1. Turn the fuel on and move the throttle to the half open position.
2. Set the engine switch to the ON or RUN position.
3. Open the fuel valve.
4. Move the choke to the ON position for cold starts. For warm starts, attempt to start without the choke
first to avoid flooding.
5. Pull the recoil starter handle firmly to start the engine.
6. When the engine starts, gradually back off the choke until the engine runs with no choke.
