10
BE-AGMZXXX USER MANUAL
DRIVE BELT ADJUSTMENT
Loosen the Screw A and B that locks the support shaft and loosen the counter nut C.
Loosen the screws that lock the gear box on the mounting plate D.
Adjust the drive belt tension. The correct belt tension is achieved when the belt can be deflected by the belt
thickness about 10mm at the center point between the pulleys.
Align the gearbox so the drive shaft is parallel with the body.
Use a straight edge to make sure the belt pullies are in-line and running true.
If mis-angled, call your dealer or service agent for technical support.
Fit the safety covers and tighten the mounting bolts before operation.
TRANSPORT
WORKING SPEED
The working speed depends on quality, diameter and height of the material to be cut; for efficient mower
performance it must be between 2 and 5 MPH. The power take-o_ speed must be 1000 RPM maximum.
Operate the mower at its full rated PTO speed to maintain blade speed for a clean cut.
DANGER!
Do not exceed the rated PTO speed for the implement. Excessive PTO speeds can cause driveline or blade
failures resulting in serious injury or death.
ROAD TRANSPORT
Extreme caution should be used when transporting the tractor and implement on public roadways.
The tractor must be equipped with all required safety warning features including SMV emblem and flashing
warning lights which are clearly visible from the rear of the unit. Make sure you are in compliance with all
local regulations regarding transporting equipment on public roads and highways. Do not exceed 20 MPH
(32KPH).
Reduce speed on rough roads and surfaces. Always use hazard flashers on the tractor when transporting
unless prohibited by law.
