7
MABasic 200, 400, 450, 850
GB
WARNING
►
Check for secure clamping of the
electromagnets on the substrate
before every use (see section
Pre-
paring
).
►
Secure the machine with the safety
lashing strap supplied when working
from an inclined or vertical position or
during overhead work. The machine
could fall down if the magnet is loos-
ened or the power fails.
►
Check that the tool is tightened
securely before using (see section
Inserting the tool
).
►
Do not allow the connecting cable to
hang over edges (trip effect).
Preventing damage
ATTENTION
Potential damage to property if the
machine is improperly used!
Observe the following instructions to
avoid damage to property:
►
Before connecting the machine,
compare the connection data (voltage
and frequency) on the type plate with
those of your mains power supply.
The data must correspond in order to
avoid damage to the machine.
►
Always use the handle to carry the
machine and not the connecting
cable.
►
Do not pull the mains cable to remove
the plug from the mains socket.
ATTENTION
►
Do not crush the connecting cable.
►
Do not subject the connecting cable
to heat or chemical liquids.
►
Do not pull the connecting cable
across sharp edges or hot surfaces.
►
Lay the connecting cable in such
a way that it cannot be caught and
wound up in the rotating part of the
machine.
Safety appliances
Restart protection
NOTE
►
The machine stops automatically
when the magnetic clamp is switched
off or if the power supply is interrupt
-
ed.
In order to prevent the machine from
starting unexpectedly after switching on the
magnetic clamp again or after reconnection
following interruption to the power supply
("restart protection"), the machine must be
switched on using the ON/OFF switch.
Symbols on the machine
The symbols on the machine have the
following meaning:
Symbol Meaning
Electric shock hazard!
Read the operating instructions
before beginning work!
Wear protective goggles and
ear protection!
Safety
