Pg. 9
HEATER/FIREPLACE OPERATION
CONTROL PANEL
INSTALLING CRYSTAL STONES
•
This appliance has a safety-cut off that will engage if the fireplace overheats. The fireplace
will NOT automatically reset for safety reasons. To reset the appliance, unplug the unit for
15 minutes and then plug it back in.
•
This appliance can be controlled by the panel on the unit or the remote.
•
Do not press the buttons more than once in two seconds; it takes some time for the
fireplace to respond.
ON/OFF:
Turn the heating/display effect on and off.
DIMMER:
Controls the brightness levels. Press to cycle through 5 dimness levels and the OFF setting.
HEAT 1/HEAT 2:
Controls the heating level. Press to cycle through the low setting (500W), high setting
(1500W), and the OFF setting.
Replace glass and secure again with the two screws
that was previously removed.
ON/OFF
DIMMER
HEAT 1
HEAT 2
24
