9
8
Place the pump and manifold in the center of the Power Cloner (fig. 1.4).
Fig. 1.1
Fig. 1.2
Unpack unit (fig. 1.1).
Attach the drain hose to the 90° fitting on the left side of the
unit. Make sure the valve on the drain hose is in closed posi
-
tion (fig. 1.2).
Using as a Power Cloner
Golden Grow Power Cloner Assembly (optional accessory)
Place the Power Cloner in the MotherShip (fig. 1.3).
Run the Water pump power cord up the channel on the back of the chamber, and plug the pump into the “
Accessory
”
socket (fig. 1.5).
The “
Accessory
” socket runs off of the Accessory On/Off switch. To run power to the Golden Grow Power Cloner,
turn the Accessory On/Off switch ON.
• z
Do not use air stones when using unit as a cloner.
WARNING
• z
Do not plug your pump in until you have water in the unit. Running your pump dry will burn it out.
WARNING
Fig. 1.4
Fig. 1.3
Fig. 1.5
Golden Grow Power Cloner: Filling & Draining
Filling
To fill the Power Cloner, prepare the R
ubbermaid
by connecting the drain
hose to
it
. Make sure the valve is closed. Add 11 litres
of pH balanced
water. ( fig. 1.9) Lift the lid on the Power Cloner enough to place the other
end of the
Rubbermaid
drain hose inside. Elevate the
Rubbermaid
and
open the valve on the drain hose. Gravity will feed the nutrient mixture
into the Power Cloner. When done, close the drain hose valve, remove the
drain hose, and replace the Power Cloner lid securely.
Draining
To drain the water out of your unit, connect the drain hose from the unit
to the fitting on the Rubbermaid.
Plug your pump into the “
Accessory
” socket and turn on the
Accessory
On/Off
switch
Open the valve on the drain hose. Water will now pump into the
Rubbermaid
.
When the water stops flowing, close the valve on the drain hose, turn the
Accessory On/Off
switch off, then disconnect the drain hose from the
Rubbermaid
(fig. 1.10).
Fig. 1.9
Fig. 1.10
