GSF3016HN
Owner’s Manual
8
Step 3 (Cart Back Panel Assembly)
a) Loosen the lower pre-installed bolt on the leg of left
cart side panel and allow 1/4 bolt’s length to extend
from the leg.
b) Align the hole on the cart back panel (P) with the
extended two bolts on the leg. Push down on the cart
back panel until it locks into place.
c) Align the middle hole on the leg of left cart side panel
with the hole on the cart back panel (P), and then insert
one bolt (AA) with one spring washer (CC) and one flat
washer (DD) into each pre-drilled hole. Tighten by
hand until secure.
d) Repeat the procedure for the assembly of cart back
panel and right cart side panel.
e) Go back and tighten all the bolts using the screwdriver
provided.
Step 4 (Heat Insulation Panel Assembly)
a) Align each hole on the heat insulation panel (M) with the
hole on upper cart front beam (O) and upper cart back
beam (N), then insert one bolt (AA) with one spring
washer (CC) and one flat washer (DD) into the holes,
then tighten by hand until secure.
b) Go back and tighten all the bolts using the screwdriver
provided.
